Asus P5KPL - Boot Menu; Boot Device Priority; Boot Settings Configuration

Chassis Q-Fan Control [Disabled]
Allows you to enable or disable the Q-Fan control. Configuration options: [Disabled] [Enabled]
Power Fan Speed [Ignored] or [N/A]
The onboard hardware monitor automatically detects and displays the Power fan speed in
rotations per minute (RPM). If the fan is not connected to the motherboard, the field shows
N/A. Select Ignored if you do not wish to display the detected speed.
VCORE Voltage, 3.3V Voltage, 5V Voltage, 12V Voltage [xxxV] or [Ignored]
The onboard hardware monitor automatically detects the voltage output through the onboard
voltage regulators.
2.6 Boot menu
The Boot menu items allow you to change the system boot options. Select an item then
press <Enter> to display the sub-menu.
BIOS SETUP UTILITY
Main Advanced Power
HBootE
Tools Exit
Boot Settings
— '
soot Settings Configuration
Security
Specifies the Boot
Device Priority
sequence.
h virtual drivo (Dra-vu
B:) may appear i;hon you
Get the CD-ROM drivo a'*
the Srnt boot rfnvice.
2.6.1 Boot Device Priority
1st ~ xxth Boot Device
These items specify the boot device priority sequence from the available devices. The
number of device items that appears on the screen depends on the number of devices
installed in the system. Configuration options: [Removable Dev.] [Hard Drive] [ATAPI CD-
ROM] [Disabled]
2.6.2 Boot Settings Configuration
Quick Boot [Enabled]
Enabling this item allows the BIOS to skip some power on self tests (POST) while booting to
decrease the time needed to boot the system. When set to [Disabled], BIOS performs all the
POST items. Configuration options: [Disabled] [Enabled]
Full Screen Logo [Enabled]
This allows you to enable or disable the full screen logo display feature. Configuration
options: [Disabled] [Enabled]
Set this item to [Enabled] to use the ASUS MyLogo2™ feature.
ASUS P5KPL/EPU
1-17