Asus P5WDG2 WS Professional - Page 63

ASUS P5WDG2 WS ProfessionalASUS P5WDG2 WS Professional
ASUS P5WDG2 WS ProfessionalASUS P5WDG2 WS Professional
ASUS P5WDG2 WS Professional
2-372-37
2-372-37
2-37
9.9.
9.9.
9.
Chassis intrusion connector (4-1 pin CHASSIS)Chassis intrusion connector (4-1 pin CHASSIS)
Chassis intrusion connector (4-1 pin CHASSIS)Chassis intrusion connector (4-1 pin CHASSIS)
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends a
high-level signal to this connector when a chassis component is
removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
P5WDG2-WS PRO
®
P5WDG2-WS PRO Chassis intrusion connector
CHASSIS
+5VSB_MB Chassis Signal GND
(Default)