3-44 Chapter 3: BIOS setup
Drive Xpert Mode Update:
Update To Super Speed [Press Enter]
Allows you to use Super Speed function. Plug two identical SATA hard disks
in the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors onSATA_E2 (white, port 1) connectors on
the motherboard and press <Enter>and press <Enter>
Update To EZ Backup [Press Enter]
Allows you to usellows you to use EZ Backup function. Plug two identical SATA hard disks in. Plug two identical SATA hard disks in
the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors on theSATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors on the connectors on theconnectors on the
motherboard and press <Enter>.and press <Enter>.
Update To Normal Mode [Press Enter]
Allows you to use the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1)the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1)
connectors as normal SATA connectors. as normal SATA connectors.
When using one hard disk in Normal Mode, connect the hard disk to the
SATA_E1 (orange, port 0) connector on the motherboard.
Drive Xpert Device(s) List:
Port 0 (Orange) / Port 1 (White)
Press <Enter> to display the information of the hard disks which are
connected to the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1)
connectors on the motherboard.
To Next Page
Loading...
