Patriot PVS34G1333ELK 4GB(2 x 2GB) DS - - 9-9-9-24 1.5 •
Patriot PVS34G1333LLK 4GB(2 x 2GB) DS - - 7-7-7-20 1.7 • •
Patriot PVT36G1333ELK 6GB(3 x 2GB) DS - - 9-9-9-24 1.65 • • •
PQI MFACR423PA0105 2GB DS PQI PQC32808E15R - - • • •
Silicon
Power
SP001GBLTU1333S01 1GB SS NANYA NT5CB128M8AN-CG - - • • •
Silicon
Power
SP001GBLTU133S02 1GB SS S-POWER I0YT3E0 9 - • • •
Silicon
Power
SP002GBLTU133S02 2GB DS S-POWER I0YT3E0 9 - • • • •
Slicon Power SP001GBLTE133S01 1GB SS NANYA NT5CB128M8AN-CG - - • • •
Slicon Power SP002GBLTE133S01 2GB DS NANYA NT5CB128M8AN-CG - - • • • •
UMAX E41302GP0-73BDB 2GB DS UMAX U2S24D30TP-13 -
6 DIMM Slots
• 2 DIMM: Supports two (2) modules inserted into slot A1 and B1 as one pair
of Dual-channel memory configuration.
• 3 DIMM: Supports three (3) modules inserted into the red slots (A1, B1 and
C1) as one set of Triple-channel memory configuration.
• 4 DIMM: Supports four (4) modules inserted into the red slots (A1, B1 and
C1) and the grey slot A2 as one set of Triple-channel memory configuration
• 6 DIMM: Supports six (6) modules inserted into both the red slots and the
grey slots as two set of Triple-channel memory configuration.
• When installing total memory of 4GB capacity or more, Windows 32-
bit operation system may only recognize less than 3GB. Hence, a total
installed memory of less than 3GB is recommended.
• It is recommended to install the memory modules from the red slots for
better overclocking capability.
• The default DIMM frequency depends on its Serial Presence Detect (SPD),
which is the standard way of accessing information from a memory module.
Under the default state, some memory modules for overclocking may
operate at a lower frequency than the vendor-marked value.
2-24 Chapter 2: Hardware information
To Next Page
Loading...
