2-6
Chapter 2: Basic Installation
Chapter 2
2.1.4 M.2 installation
Supported M.2 type varies per motherboard.
• The illustrations only show the installation steps for a single M.2 slot, the steps are
the same for the other M.2 slots if you wish to install an M.2 to another M.2 slot.
• Use a Phillips screwdriver when removing or installing the screws or screw stands
mentioned in this section.
• The M.2 is purchased separately.
For M.2_1
When installing an M.2 Type 2242, 2260, 2280 M.2 to M.2_1, you may need to use the
removable screw stand.
1. Remove the screws from the heatsink.
2. Gently lift and swivel the heatsink away from the M.2 slot.
The heatsink has a cable connected to the motherboard, ensure not to pull on the heatsink
as this may result in damages to the cable.
1
1
2
To Next Page
Loading...
