EasyManua.ls Logo

Asus SABERTOOTH 990FX - North Bridge Configuration

Asus SABERTOOTH 990FX
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-16 Chapter 3: BIOS setup
Chapter 3
3.5.2 North Bridge Conguration
Main
Ai Tweaker
Advanced Monitor Boot Tool
Exit
IOMMU is support on Linux based
systems to convert 32bit I/O to 64bit
MMIO.
Back Advanced\ North Bridge >
UEFI BIOS Utility - Advanced Mode
North Bridge Conguration
IOMMU Mode Disabled
> Memory Conguration
Initate Graphic Adapter PEG/PCI
IOMMU [Disabled]
Conguration options: [Disabled] [64MB]
Memory Conguration
Bank Interleaving [Auto]
Allows you to enable Memory Bank Interleaving fuction. Conguration options: [Auto]
[Disabled]
Channel Interleaving [Auto]
Allows you to enable Memory Channel Interleaving fuction. Conguration options:
[Auto] [Disabled]
ECC Mode [Enabled]
Allows you to enable or disable the ECC Mode.
Conguration options: [Enabled] [Disabled]
Power Down Enable [Disabled]
Allows you to enable or disable DDR power down mode.
Conguration options: [Enabled] [Disabled]
Memory Hole Remapping [Enabled]
Allows you to enable or disable Memory Hole Remapping fuction.
Conguration options: [Enabled] [Disabled]
DCT Unganged Mode [Enabled]
Allows you to select unganged DRAM mode (64-bit width).
[Enabled]: Ganged mode.
[Disabled]: Unganged mose.
Initiate Graphic Adapter [PEG/PCI]
Allows you to decide which graphics controller to use as the primary boot device.
Conguration options: [PCI/PEG] [PEG/PCI]

Table of Contents

Related product manuals