Asus SABERTOOTH 990FX - SATA Configuration

ASUS SABERTOOTH 990FX
3-17
Chapter 3
3.5.3 SATA Conguration
Main
Ai Tweaker
Advanced Monitor Boot
Tool
Exit
Options for SATA Conguration.
Back Advanced\ SATA Agent Conguration >
UEFI BIOS Utility - Advanced Mode
SATA Conguration
SATA6G_1 Not Present
SATA6G_2 Not Present
SATA6G_3 Not Present
SATA6G_4 Not Present
SATA6G_5 Not Present
SATA6G_6 Not Present
> SB SATA Conguration
SB SATA Conguration
Onchip SATA Channel [Enabled]
Conguration options: [Disabled] [Disabled]
SATA Port1-Port4 [AHCI]
Allows you to set the SATA conguration. This item appears only when you set the OnChip
SATA Channel item to [Enabled].
[IDE] Set to [IDE] when you want to use the Serial ATA hard disk drives as
Parallel ATA physical storage devices.
[RAID] Set to [RAID] when you want to create a RAID conguration from the
SATA hard disk drives.
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to use the
AHCI (Advabced Host Controller Interface). The AHCI allows the
onboard storage driver to enable advanced Serial ATA features that
increases storage performance on random workloads by allowing the
drive to internally optimize the order of commands.