2-1
Chapter 2: Setup
2.1 Detaching the Base (for VESA Wall
Mount)
To detach the base, perform the following:
1. Disconnect power and signal cables. Carefully put the front of the
monitor face down on a clean table.
2. Using a coin, turn the screw counter-clockwise to loosen the screw
located at the bottom of the base.
3. Remove the base from the stand.
4. Remove the stand cover. Then loosen the 4 screws to remove the
stand.
5. Align and install the wall mount bracket on the rear of the monitor.
Screw holes for VESA wall mount
(100 x 100 mm)
• We recommend that you cover the table surface with soft cloth to prevent
damage to the monitor.
• Hold the base while removing the screw.
• The VESA wall mount kit ( 100 x 100 mm) is purchased separately.
• Use only the UL Listed Wall Mount Bracket with minimum weight/load
22.7kg (Screw size: M4 x 10 mm).
To Next Page
Loading...
