Asus VL249 Series - 2.1 Detaching the Arm;Stand (for VESA Wall Mount)

2-2
Chapter 2: Setup
2.1 Detaching the arm/stand (for VESA wall
mount)
ThedetachablestandofthismonitorisspeciallydesignedforVESAwall
mount.
To detach the arm/stand
1. Disconnectpowerandsignalcables.Carefullyputthefrontofthe
monitorfacedownonacleantable.
2. Useyourngerstoloosenthescrewlocatedatthebottomofthe
base,andremovethebasefromthestand.Andthenremovethehinge
coverfrommonitorbodybyusingyourngers.
3. Useascrewdrivertoremovethetwoscrewonthearm(Figure1),and
thendetachthearm/standfromthemonitor.
• Werecommendthatyoucoverthetablesurfacewithsoftclothtoprevent
damagetothemonitor.
• Holdthestandofthemonitorwhileremovingthescrews.
1
2
• TheVESAwallmountkit(100x100mm)ispurchasedseparately.
• UseonlytheULListedWallMountBracketwithminimumweight/load12kg
(Screwsize:M4x10mm).