Asus X99-E-10G WS - Page 125

ASUS X99-E-10G WS
3-55
Chapter 3
Chassis Fan 1-2 Profile [Standard]
This item allows you to set the appropriate performance level of the chassis fan.
[Standard] Sets to [Standard] to make the chassis fan automatically adjust
depending on the chassis temperature.
[Silent] Sets to [Silent] to minimize the fan speed for quiet chassis fan
operation.
[Turbo] Sets to [Turbo] to achieve maximum chassis fan speed.
[Manual] Sets to [Manual] to assign detailed fan speed control parameters.
The following items appear only when you set Chassis Fan 1-2 Prole to [Manual].
Chassis Fan 1-2 Upper Temperature
Use the <+> or <-> keys to adjust the upper limit of the Chassis Fan 1-2
temperature. The values range from 20 to 75.
Chassis Fan 1-2 Max. Duty Cycle (%)
Use the <+> or <-> keys to adjust the maximum Chassis Fan 1-2 duty
cycle. The values range from 20% to 100%. When the CPU temperature
reaches the upper limit, the Chassis Fan 1-2 will operate at the maximum
duty cycle.
Chassis Fan 1-2 Middle Temperature
Use the <+> or <-> keys to adjust the middle limit of the Chassis Fan 1-2
temperature. The values range from 20 to 75.
Chassis Fan 1-2 Middle. Duty Cycle (%)
Use the <+> or <-> keys to adjust the middle Chassis Fan 1-2 duty cycle.
The values range from 20% to 100%. When the CPU temperature reaches
the middle limit, the Chassis Fan 1-2 will operate at the middle duty cycle.
Chassis Fan 1-2 Lower Temperature
Use the <+> or <-> keys to adjust the lower limit of the Chassis Fan 1-2
temperature. The values range from 20 to 75. The Chassis Fan 1-2 will
operate at the minimum duty cycle when the temperature is lower than the
limit.
Chassis Fan 1-2 Min. Duty Cycle(%)
Use the <+> or <-> keys to adjust the minimum Chassis Fan 1-2 fan duty
cycle. The values range from 0% to 100%. When the CPU temperature is
under the limit, the Chassis Fan 1-2 will operate at the minimum duty cycle.
Water Pump Control [Disabled]
[Disabled] Disable the Water Pump control feature.
[Auto] Detect the type of Water Pump installed and automatically switches the
mode control.
[DC mode] Enable the Water Pump control in DC mode for 3-pin Water Pump.
[PWM mode] Enable the Water Pump control in PWM mode for 4-pin Water Pump.