41/46
9.4. Save all the parameters in the Asycube
If not already done, save the parameters in the flash memory in the Asycube. If needed, it is
possible to export a vibration set or sequences as .xml files.
Please refer to chapter 7 on page 32 of this document for a detailed explanation on saving
procedures.
9.5. Configure the backlight
Please refer to chapter 8 on page 34 of this document for details on how to activate the
backlight and how to adjust its intensity.
NOTE:
For preliminary tests, it is sufficient to use the backlight activation button in the home tab of
the HMI or software commands (see next section).
9.6. Execute commands from PLC
A console mode is available in the Asyril HMI in order to test the communication with the
Asycube as well as the execution of commands as if they were sent from the client’s PLC
(Programmable Logic Controller).
NOTE:
The console mode can only be accessed with Integrator level access rights. Please refer to
the HMI user guide for more information on access rights.
Please refer to the programming guide for your Asycube for the full list of commands as well
as their detailed explanation.
Use a vibration set
Command {UV1} Response {UV1}
Select vibration set 1.
To Next Page
Loading...
Need help?
General
