EN 19
OPERATING THE INDUCTION HOB
Switching on a cooking zone
Before activating a cooking zone, place a suitable pan on the relative
cooking circumference.
• On turning any knob clockwise, a beep is emitted and all the
displays switch on; the one corresponding to the turned knob will
show the selected power value, while the others will show the value
• On turning a second knob, no beep is emitted and the display
shows the power value set for that knob.
Changing the power level
• The heating power of the cooking zones is increased by turning any
knob clockwise from “0” position, and is decreased by turning the
knob anticlockwise from the position reached. A power level can
be set between setting “0” and “9”. There is also a “Boost”setting
available.
▷ The display shows the chosen power level.
• The knob’s default position corresponds to level “0” (value display).
1. Turn the knob to set the desired power level (see “Cooking
settings”).
▷ The display shows the chosen level.
2. Turn the knob clockwise beyond power level “9” to select the
“Boost” setting.
▷ An audible signal will be sound and the display shows “P”.
3. Then reposition the knob on level “9”.
Switching off manually
• Turn all the knobs to “0” position. Each display will show a flashing
dot as in the adjacent figure; after 15 seconds all the displays will
switch off, a beep will be emitted and the appliance with go to
stand-by.
To Next Page
Loading...