EN 30
FAULTS
Induction hob
Problem Possible cause Solution
Error code
The control panel is dirty or has
water lying on it.
Clean the control panel.
You have pressed two or more keys
at the same time.
Do not operate more than one
key at the same time.
Software failure. Reset the appliance by
disconnecting it from the power
supply. Remove the plug from the
socket or switch the automatic
circuit breaker to Off.
Error code F
Other defect Contact the service department.
Oven
Problem Possible cause Solution
The oven does not switch on. The oven is not set to manual
operation.
Switch the oven to manual
operation (see ‘Operating the
oven’).
The oven does not switch on
after it has been plugged in.
No time of day has been set. Set a time of day first (see
‘Operating the oven’). The
oven is then ready for use.
The oven does not heat up. No temperature set. Set the temperature using the
temperature knob
(see ‘Operating the oven’).
To Next Page
Loading...