Why is my Atag Hob not turning on?
If your Atag hob isn't working and the display is blank, it's likely due to a power issue. Check the fuses or the electric switch to ensure a proper electrical connection.
What to do if the Atag Hob blows a fuse immediately?
If a fuse blows immediately when you switch on your Atag hob, it indicates an incorrect electrical connection. Verify the connections to ensure they are properly configured.
What does error code F00 mean on my Atag Hob?
If error code F00 appears on your Atag hob, it means the control panel is either dirty or has water on it. Clean the control panel to resolve this issue.
What does error code F8 mean on my Atag Hob?
Error codes F8 and F08 on your Atag hob indicate that the appliance has overheated. The hob has been automatically switched off. Allow it to cool down before restarting it on a lower setting.
How to stop the beeping when my Atag Hob cooking zone stops?
If a cooking zone on your Atag hob suddenly stops and you hear a signal, the preset time has likely ended. Turn off the sound by pressing the + or - button on the timer.
What does error F9 mean on Atag Hob?
If your Atag hob displays error code F9 or emits a continuous beep, this indicates that the appliance has been connected incorrectly, or the mains voltage is too high. Have your connection changed to resolve this issue.
What does error code FAN mean on my Atag Hob?
If your Atag hob shows error code FAN, it indicates poor air circulation. Ensure that the venting holes under the cooking plate are open.
What does error code F7 mean on my Atag Hob?
If your Atag hob displays error code F7, it indicates that the ambient temperature is not optimal. Switch off any nearby heat sources to allow the cooking plate to cool.
What does error code F99 mean on my Atag Hob?
If your Atag hob shows error code F99, it means that you have pressed two or more buttons at the same time. Only operate one button at a time.
What does error code FA mean on my Atag Hob?
If your Atag hob displays error code FA, it indicates that the mains voltage is too low. Contact your energy supplier to address this issue.
Identification and function of all buttons and indicators on the control panel.
How the hob prevents overheating and boiling dry with sensors.
Safety feature that automatically switches off cooking zones after a set time.
Criteria for selecting appropriate pans and testing their compatibility.
Step-by-step guide to switching on the hob and adjusting cooking power.
Using the high-power boost and understanding how cooking zones influence each other.
Table listing error codes, their causes, and recommended solutions.
To Next Page
General
