EasyManuals Logo

Atag HI6271T User Manual

Atag HI6271T
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
GB 29
Building in
Check that the cabinet and the cut-out meet the dimension and
ventilation requirement
reat the sawn ends of wooden or synthetic worktops with sealing
varnish if necessary, to prevent moisture causing the worktop to swell.
Lay the hob upside down on the worktop.
Fit the connecting cable to the appliance in compliance with
requirements (see page 28).
Remove the protective layer from the sealing tape and apply the tape
in the groove of the aluminium profi le or on the edge of the glass
plate. Do not stick tape round the corners, but cut 4 separate pieces to
seal the corners well.
Turn the hob over and lay it in the recess.
Connect the appliance to the mains. A short bleep will be heard and
all the displays will light up briefl y. e appliance is ready for use.
Check that it works properly. If the appliance has been wrongly
connected either a bleep will sound or nothing will appear in the
displays, depending on the error.
Building in INSTALLATION INSTRUCTIONS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Atag HI6271T and is the answer not in the manual?

Atag HI6271T Specifications

General IconGeneral
BrandAtag
ModelHI6271T
CategoryHob
LanguageEnglish

Related product manuals