What does it mean if green symbols are flashing on my Atag Refrigerator?
If one or more green symbols are flashing continuously and you cannot change the temperature, this indicates a malfunction alarm. The alarm signifies a fault in a technical component. Contact Technical Assistance Service.
How to turn on Atag Refrigerator if it is on standby mode?
Turn the appliance on by briefly pressing the “Temp.” button (see On/ Stand-by function).
How to fix Atag Refrigerator if the inside light does not work?
The light may need to be replaced, or there could be a malfunction of a technical component. Disconnect the appliance from the power supply and contact the Technical Assistance Service if you need a replacement.
How to fix one or more green symbols flashing continuously on my Atag KS37102B Refrigerator?
The flashing green symbols indicate a malfunction alarm, pointing to a fault in a technical component. Contact Technical Assistance Service.
What to do if there is water on the bottom of the Atag KS37102B compartment?
The defrost water drain is likely blocked. Clean the defrosting water drain.
What to do if the temperature of the Atag KS37102B compartment is too cold?
The set temperature may be too cold, or a large amount of fresh food may have been placed in the freezer compartment. Try setting a less cold temperature. If you've recently added fresh food to the freezer, allow it to fully freeze. If your refrigerator has a fan, try turning it off.
Why is there an excessive amount of frost in my Atag KS37102B freezer compartment?
The excessive frost could be due to the freezer door not sealing correctly. Check for obstructions preventing a proper seal. You may also need to defrost the freezer and ensure the appliance was installed correctly.
Why is the temperature inside my Atag KS37102B Refrigerator compartments not low enough?
Several factors could be at play. Please ensure that: the doors are closing properly, the refrigerator isn't near a heat source, the set temperature is appropriately cold, and the air vents at the bottom aren't blocked, which could obstruct air circulation.
Why is my Atag Refrigerator control panel switched off and not working?
The Atag Refrigerator may not be working due to a power supply issue. Please verify that: there is no power outage; the plug is correctly inserted into the socket and the mains double-pole switch (if present) is in the correct position to allow power; the household electrical protection devices are working correctly; and the power cable is not damaged.
Why is the temperature inside my Atag Refrigerator not cold enough?
Several factors might be at play. Ensure the doors are sealing correctly, the refrigerator isn't near a heat source, the temperature setting is appropriate, and the air vents at the bottom aren't blocked. Check these to ensure optimal cooling performance.
General| Height | 185 cm |
|---|---|
| Width | 60 cm |
| Cooling System | No Frost |
| Number of Shelves | 4 |
| Color | Black |
| Category | Refrigerator |
| Type | Freestanding |
To Next Page
