Why is my Atag KS37178A not cold enough?
If the temperature inside your Atag Refrigerator compartments isn't cold enough, several factors could be the cause. First, ensure the doors are closing correctly. Next, check that the refrigerator isn't near a heat source. Also, verify that the set temperature is adequate for your needs. Finally, make sure that air circulation through the vents at the bottom of the appliance isn't blocked.
How to reduce frost in Atag KS37178A freezer?
If you notice an excessive amount of frost in the freezer compartment of your Atag Refrigerator, it could be due to the door not closing properly. Check for any obstructions preventing a tight seal. It may also be necessary to defrost the freezer compartment. Finally, ensure that the appliance has been installed correctly.
Why is my Atag KS37178A control panel off?
If the control panel of your Atag Refrigerator is off and the appliance isn't working, there might be a power supply issue. Check the following: * Ensure there isn't a power outage. * Verify the plug is properly inserted into the power socket and that the mains double-pole switch (if present) is in the correct position. * Confirm the household electrical system protection devices are working correctly. * Inspect the power cable for any damage.
Why is my Atag Refrigerator too cold?
If the refrigerator compartment of your Atag Refrigerator is too cold, the set temperature might be too low. Try setting a less cold temperature. Also, if you've recently placed a large amount of fresh food in the freezer compartment, wait until it has fully frozen. You can also turn off the fan (if present).
What to do if Atag KS37178A has water at the bottom?
If you find water at the bottom of the refrigerator compartment of your Atag Refrigerator, the defrost water drain may be blocked. You should clean the defrosting water drain.
Why is the light flashing in my Atag Refrigerator?
If the inside light of your Atag Refrigerator is flashing, the door alarm is active, which means the refrigerator compartment door has been open for too long. Close the refrigerator door to stop the alarm. After closing, check if the light works when you reopen the door.
How to turn on Atag KS37178A Refrigerator?
If your Atag Refrigerator seems unresponsive, it might be in standby mode. Briefly press the 'Temp.' button to turn the appliance on.
Atag Refrigerator light not working, how to fix?
If the inside light of your Atag Refrigerator isn't working, the light may need to be replaced or there may be a malfunction of a technical component. Disconnect the appliance from the power supply and contact the Technical Assistance Service if you need a replacement.
What does flashing green light mean on Atag Refrigerator?
If one or more green symbols are flashing continuously on your Atag Refrigerator and you cannot change the temperature, it indicates a malfunction alarm, meaning there's a fault in a technical component. Contact Technical Assistance Service.
What to do if water is at the bottom of Atag Refrigerator?
If you notice water at the bottom of your Atag Refrigerator compartment, the defrost water drain is likely blocked. To resolve this, clean the defrosting water drain as described in the section “Cleaning and Maintenance”.
General| Brand | Atag |
|---|---|
| Model | KS37178A |
| Category | Refrigerator |
| Language | English |
To Next Page
