EN 6
USE
Operation
Setting the current time of day
When the oven is connected to the power network, ‘AUTO’ (B) and the
figures on the timer will flash. Set the current time of day as follows:
1. Press in the ‘–’ and ‘+’ buttons simultaneously till you hear a beep.
A point(D) between the figures of the timer will start flashing.
2. Set the correct time of day using the ‘–’ and ‘+’ buttons.
You will hear a beep confirming the time selected. The ‘heat’ symbol
(C) stays lit.
The time can be changed whenever you like; follow the instructions
above to do so.
Using the oven
The oven has 9 oven functions and 1 cleaning function. Consult the
table to select the right oven function to prepare a dish.
1. Place the dish in the oven.
For some dishes the oven has to be preheated first.
2. Turn the ‘oven function knob’ to the oven setting desired.
3. Set the oven to the desired temperature using the thermostat knob
(between 50-250 °C).
The oven will start the oven function set and heat the oven to the
temperature set. A check light will go on above the thermostat knob
and will go off once the temperature set is reached.
Remarks
• The temperature can be adjusted during preparation.
• If the oven is in use, operation of the hot air element and the top
and bottom elements will regularly be interrupted to regulate the
temperature.
Turning off the oven
• Turn the oven function knob and temperature knob to the o
position.
Please note! If the oven does not work, there may be a timer
function active. Cancel all timer functions by pressing the ‘-’ and ‘+’
buttons till ‘AUTO’ disappears from the display. Wait a few seconds
till the change is saved.
A
U
T
O
oven function
knob
timer
temperature
knob
CD
B
A
To Next Page
Loading...
