Atag Q 25S - Adjustments

The boiler has a large number of settings options.
We advise you to contact your installer
for
adjusting the boiler to the required settings.
Adjusting
the
flow
water
temperature
(CH)
-
Press the Mode key briefly
(from the Technical reading).
The display will show PARA .
Press the Step key once.
The display will show 1 85 .
Press the + or the - key to alter the adjustments,
if necessary.
Press the Store key to confirm the setting.
The display will flash once.
Press the Mode key briefly.
The display will show StbY for a short while
and
will return to the Technical reading.
The flow water temperature that has been
adjusted
-
-
-
-
only applies to the central heating and is independent of the hot water facility for
the
cylinder.
Q
14
Operating
instructions
Adjustments