To Next Page

To Previous Page

Dismantling and loss of voltage

Loss of voltage

The thermostat works without batteries and obtains its required

energyviatheboiler.Whenthethermostatisremovedfrom

itsmountingplate,allsettingsarestoredinthememory.Only

after an interruption of approximately 4 hours do you have to

reset the day and time.

Dismantling

Disconnect the boiler from the mains (pull the plug

from its socket or use the on/off button).

•Thethermostathingesatthetopandisclamped

at the bottom (in the middle).

Remove the thermostat from its mounting plate by

rmlygrabbingholdofitwith2handsandreleasing

the bottom by pulling it forward.

Retting

•Hookthetopofthethermostatonthemounting

plate and tip it downwards until it snaps at the

bottom.

•Reconnecttheboilertothemains.Set,whenthe

thermostat asks you to do so, the correct time and

day and the thermostat will be ready for use again.

Bear in mind that it may take a while before the boi-

ler is back on standby due to the automatic deairing program.

Depending on the boiler type this may take between 7 and 17

minutes (refer to the boiler’s manual).

•Refertochapter5.7forexplanationsregardingsettingthe

correct day and time.

Atag WIZE User Manual

Questions and Answers: