Atag XL110 - Page 42

Installation & Servicing instructions ATAG XL
42
9.4 Setting the maximum ow water temperature with On/O󰀨-control
P101 = 0
Setting the maximum ow water temperature with connected outdoor sensor T4
(starting with illuminated display):
1. Press the right arrow button:
The display shows: Basic Settings;
2. Press the OK button;
3. Press the right arrow button until CH temp:
The display shows: CH temp 85°C;
4.Pressthe+or-buttontoadjustthedesiredowtemperatureandpresstheOKbut-
ton.
Setting the maximum ow water temperature without outdoor sensor T4
(starting with illuminated display):
1. Press the right arrow button until Timeprog-options;
2. Press the OK button;
3. Press the right arrow button until Timeprog CH;
4. Press the OK button;
5. Press the right arrow button until Day Temp;
6. Press the OK button;
The display shows: T_day
7. Pressthe+or-buttontoadjustthedesiredowtemperatureandpresstheOKbut-
ton.
Basic
Settings
CH temp
85 °C
Timeprog
options
Timeprog
CH
Day
Temp
T_day
85 °C