Turn System Off
Press 0 0.
Turn System On
When the system is off, it answers after 10
rings, announces “The machine is off,” and
beeps twice.
1 Press 0 to turn the system on.
2 The system beeps twice and is ready
to answer calls and record messages.
If the system beeps five times, the
memory is full.
REMOTE OPERATION
6
Memory Full
The system answers after 10 rings, then
announces “Memory is full,” and beeps
twice, you must delete messages to make
room for new ones.
1 Enter the Remote Access Code after
two-beep signal.
2 Listen to messages, and delete some
or all of them.
3 Press 0 to make sure your system is
on before you hang up.
To Next Page
Loading...
