To Next PageTo Next Page
Need help?Do you have a question about the AT&T 1718 and is the answer not in the manual?
General| Brand | AT&T |
|---|---|
| Model | 1718 |
| Answering System | Digital |
| Recording Time | 14 minutes |
| Caller ID | Yes |
| Remote Access | Yes |
| Voice Prompts | Yes |
| Time/Day Stamp | Yes |
| Message Alert | Yes |
| Call Waiting Caller ID | Yes |
| Display | LCD |
| Power Source | AC adapter |
| Phonebook Capacity | 50 names/numbers |
Guidance on selecting a location for the answering system and necessary connections.
Instructions for powering the answering system on and off for operation.
Configures whether the system records messages or plays a pre-recorded announcement.
Sets the number of rings before the system automatically answers a call.
Allows setting a three-digit code to access features remotely via phone.
Enables listening to callers' announcements as they are made.
Announces the caller's phone number between the second and third rings.
Announces the caller's phone number when playing back a recorded message.
Controls whether blocked calls are accepted or rejected with a pre-recorded message.
Provides audible beeps every 15 seconds when new messages are received.
Procedure to set the current day and time for accurate message logging.
Instructions on recording a personalized announcement for callers.
How to listen to incoming calls or speak with the caller directly.
Guide to recording a personal memo to be stored as a message.
Method to check the remaining recording time available on the system.
Explains how to play, save, and delete incoming messages and memos.
Steps to connect to the answering system remotely using a touch-tone phone.
List of commands and their corresponding key presses for remote operation.
Provides solutions for common operating issues and contact information.
Troubleshooting steps for when the system fails to answer calls after the specified rings.
Addresses issues where the system is unable to record new incoming messages.
Solutions for when remote commands are not recognized or executed by the system.
Guidance on system behavior and clock reset after a power interruption.
