INSTALLATION
1 Connect the line cord.
Plug one end of the telephone line
cord into the jack labeled TEL LINE
on the back of the system. Plug the
other end into a phone wall jack.
2 Connect the telephone.
NOTE: If you do not want to connect a
telephone, skip to Step 3.
Plug the line cord from the telephone
into the jack labeled TEL SET on the
back of the system.
3 Connect the power cord.
Plug the power cord into the jack
labeled POWER on the back of the
system. Plug the power cord into an
electrical outlet not controlled by a
wall switch. Fit the power cord
behind the strain relief tab. (When
you connect the system to power, the
Message Window flashes CL to
indicate that you need to set the
clock. See “Setting the Clock” in the
OPERATION section of this manual.)
To Next Page
Loading...
Need help?
General
