AT&T 1725 - Changing the Remote Access Code

OPERATION
Changing the Remote Access Code
The Remote Access Code is preset to 500.
You can change the Remote Access Code
to any three-digit number from 500–999.
DO NOT pick the same number as that
assigned to the Priority Calling Code.
1 Press g. The Message Window
displays CH.
2 Hold down c for at least two
seconds. The system announces “First
digit.”
3 Press / or ? to change
the digit.
4 When the Message Window displays
the desired first digit, press c. The
system announces “Second digit.”
5 Press / or ? to change
the digit.
6 When the Message Window displays
the desired second digit, press c.
The system announces “Third digit.”
7 Press / or ? to change
the digit.
8 When the Message Window displays
the desired third digit, press c.
The system announces the new
Remote Access Code.