AT&T 7220 User Manual

O P E R A T I N G R A N G E
Part 2
© 1998 Philips Consumer Communications L.P. All rights reserved.
Printed in Mexico. 848233698 Issue 1AT&T
○○○○○○○○○○○○ ○○○○○○○○○○○○
User’s Manual
for Cordless
Telephone 7220
Fold open this manual for information about this
telephone’s installation and operation. Please
read Part 1— Important Product Information,
included in this package.
2
This cordless telephone operates at the
maximum power allowed by the Federal
Communications Commission (FCC).
Even so, the handset and base can
communicate over only a certain distance
—which can vary with the locations of the
base and handset, the weather, and the
construction of your home or office.
If the handset is moved to a point where
the base and handset can no longer
communicate, the handset will sound two
short beeps when you make a call,
indicating that you are out of range. Move
close to the base to restore normal
operation.
If you receive a call while you are out of
range, the handset might not ring — or if
it does ring, the call might not connect
when you press P. Move closer to the
base, then press P to answer the call.
If you move out of range during a phone
conversation, you will hear noise or
interference. To improve reception, move
closer to the base.
If you move out of range while on a call,
the phone will be left “off the hook.” To
hang up properly, walk back into range,
periodically pressing P until the
PHONE light goes off.
Changing Channels
This cordless telephone has an advanced
AutoSelect feature that minimizes the
chance of interference.
In the unlikely event that you notice noise or
interference while using the handset:
1 Press C.
2 If the interference does not clear,
continue to press C until you find
a clear channel (your call will not be
interrupted
—OR—
Move closer to the base and press
C.
NOTE: You must be in range to change
channels.

AT&T 7220 Specifications

General

Brand	AT&T
Model	7220
Category	Cordless Telephone
Language	English

Summary

OPERATING RANGE

Changing Channels

Explains how to minimize interference by changing channels.

INSTALLATION

Install the handset battery

Details how to install the battery pack into the handset.

Connect the telephone line cord

Guides on connecting the telephone line cord to the base and jack.

Connect the power cord

Explains how to connect the power cord and AC adapter.

Charge the handset batteries

Instructs on charging the handset batteries for the first time.

OPERATION

Making A Call

Steps to initiate a phone call.

Answering a Call

How to receive and answer incoming calls.

Ending a Call

Procedure to terminate an active phone call.

Redial

How to redial the last number called.

MEMORY

Store Speed-Dial Numbers

Steps to store phone numbers for speed dialing.

Dialing Speed-Dial Numbers

How to dial numbers stored in memory.

Storing a Pause

How to store pauses for use with switchboards.

BATTERIES

Charging the Handset Battery Pack

Instructions for charging the handset battery pack.

Replacing the Handset Battery Pack

Detailed steps for replacing the handset battery.

IN CASE OF DIFFICULTY

If the phone does not work at all

Basic checks when the phone is completely non-functional.

If you have no dial tone

Steps to take when no dial tone is heard.

If you hear noise or interference

Solutions for audio noise or interference issues.