base goes on to show the handset
is in the right position to charge
the batteries. The battery requires
10 hours of charging.
8 Check for dial tone.
After the batteries are charged, pick
up the handset and extend the base
antenna. Check for dial tone by press-
ing P; the PHONE light should go
on and you should hear a dial tone.
9 Set the dial mode.
If you have touch tone service, the
phone will be ready to use as soon
as the battery is charged.
NOTE: If you have dial pulse service,
you’ll need to set the dial mode. Press
Pp, #, #, #, 3. To return
to touch tone dialing with touch tone
service, press
Pp, #, #,
#, 8.
CAUTION: Use only AC power
adapter supplied with this
telephone. Power Supply 4906 or 4898.
Input: 117V AC, 60Hz, 6W.
Output: 12V DC, 200 mA.
The instructions below are for both table
and wall installation.
1 Choose a spot near an electrical
outlet and a telephone jack.
• This phone requires a modular
telephone jack and a standard
electrical outlet (110v AC).
2 Install the handset battery.
(For an illustration of battery instal-
lation, see “BATTERIES.”)
• Plug the battery pack connector into
the handset and place the battery
pack into the case, so the wires rest
between the battery pack and
the case.
• Place the battery case cover on the
handset by sliding it on its track up
over the battery case until it snaps
firmly in place.
3 Set the handset ringer switch.
Set the switch on the side of the
handset to ON so the handset will ring.
When this switch is set to OFF the
handset will not ring.
NOTE: if you set the ringer switch to
OFF, the handset battery will last longer.
However, when the ringer is set to OFF,
you will always need to press P
to answer a call, even when the hand-
set has been in the base.
4 Connect the telephone line cord.
Plug one end of the telephone line
cord into the jack on the back of the
base. (If you are wall mounting the
phone, wrap the excess cord in the
groove on the bottom of the base.)
Plug the other end of the line cord into
a modular phone jack. Make sure the
plug snaps firmly in place.
5 Mount the base on the wall.
(WALL MOUNTING ONLY) Hold
the base so that the mounting knobs
on the standard wall jack will fit into
the holes on the bottom of the base.
Slide the base down onto the knobs
until it locks into place.
6 Connect the power cord.
Plug the power cord into the jack
labeled DC POWER on the back of the
base. Plug the AC adapter on the
power cord into an electrical outlet.
7 Charge the handset batteries
before use.
Place the handset face down in the
base. The CHARGING light on the
I N S T A L L A T I O N
○○○○○○○○○○○○○○
○○○○○○○○○○○○○○
Base Antenna
Charging/Handset
in Use Light
PAGE/HANDSET LOCATOR Button
Telephone Line Cord
Power Cord
Standard AC Outlet
AC Adapter
Modular Jack
To Next Page
Loading...
