AT&T BL102-2S - Telephone Base and Charger Installation; Telephone Base Installation; Charger Installation

8
Getting started
Telephone base and charger installation
Install the telephone base and charger, as shown below.
The telephone base is ready for tabletop use. If you want to change to wall-
mounting, see Installation options on page 13 for details.
IMPORTANT INFORMATION
1.
Use only the power adapter(s) supplied with this
product. To order a replacement power adapter,
visit our website at
https://telephones.att.com or call
1 (800) 222-3111. In Canada, dial
1 (866) 288-4268.
2. The power adapters are intended to be correctly
oriented in a vertical or oor mount position. The
prongs are not designed to hold the plug in place
if it is plugged into a ceiling, under-the-table or
cabinet outlet.
Plug the power adapter into a power
outlet not controlled by a wall switch.
Charger installation
Telephone base installation
f Raise the antenna.
f Plug one end of the
telephone line cord
into the telephone
jack on the back of
the telephone base.
f Route the power
adapter cord
through this slot.
f Plug the small end of the
telephone base power adapter
into the power adapter jack on
the back of the telephone base.
f Plug the large end of the telephone
base power adapter into a power
outlet not controlled by a wall
switch.
f Plug the other end
of the telephone
line cord into a
telephone jack or a
DSL lter.
If you have DSL
high-speed Internet
service, a DSL lter (not
included) is required.
The DSL lter must
be plugged into the
telephone wall jack.
Telephone line cord