Multiple handset use
42
Push-to-talk (PTT)
PTT call to a single device
1. There are a few ways to begin a PTT call to a
single device. When the handset is not in use:
If you have a two-handset system,
press and hold PUSH TO TALK.
If you have more than two handsets:
w Press PUSH TO TALK on the handset, then
use the dialing keys to enter the destination
device number.
-OR-
w Press PUSH TO TALK on the handset. Press
CID or DIR to highlight the destination
device number, then press MENU/SELECT or
PUSH TO TALK.
The handset shows Connecting to HANDSET
X...
(HANDSET represents the handset name, X represents the
destination handset number).
When the connection is made,
both your and the destination device screens display
Press and hold [PTT] to talk.
2. Press and hold PUSH TO TALK. A chirp indicates
your microphone is on. Speak towards the device.
Your voice is broadcast to the destination device.
While you are speaking, your handset shows
PTT To handset: X.
3. Release PUSH TO TALK after speaking. Both devices beep once
again and the screens show Press and hold [PTT] to talk, then
you can press and hold PUSH TO TALK to continue speaking or
the destination device can respond (see Answer a PTT call on
page 44).
4. To end the PTT call, press
or place the handset in
the telephone base or charger. The handset shows
Push to talk Ended.
PUSH TO TALK
>HANDSET X
Connecting to
HANDSET X...
Press and hold
[PTT] to talk
PTT To
handset: X
To Next Page
Loading...
