Telephone operation
43
Options while on calls
Temporary tone dialing
If you have pulse (rotary) service only, you can switch from pulse to touch-tone
dialing temporarily during a call. This is useful if you need to send touch-tone
signals to access your telephone banking or long distance services.
1. During a call, press
TONE .
2. Use the dialing keys to enter the desired number. The telephone sends
touch-tone signals.
3. The telephone automatically returns to pulse dialing after you end the call.
Blind transfer
While on an outside call, you can transfer the call to a specific device or any
device without notifying them.
To transfer an outside call from a handset:
1. During the call, press MENU/SELECT.
2. Press MENU/SELECT to choose Transfer.
If you have one handset, the outside call is put on
hold and your handset shows Transferring call... The
telephone base rings and shows
Transfer from HANDSET X.
If you have more than one handset, your screen shows
TRANSFER TO: Use the dialing keys to enter a specific
device number (0 for the telephone base, 1-9 for
handsets 1-9, TONE followed by 0-2 for handsets
10-12, or TONE followed by # for all devices), or
press qCID or pDIR to scroll to the desired device and
press MENU/SELECT. The outside call is put on hold
and your handset screen shows Transferring call... or
Transferring call to all... The other device rings and
shows Transfer from HANDSET X (HANDSET represents the handset
name, X represents the handset number).
3. To answer the call on the destination handset, press PHONE/FLASH or
/SPEAKER. To answer the call on the telephone base, press
/SPEAKER. The initiating handset shows Call transferred and goes to
idle mode.
•
•
>Transfer
Intercom
p
q
TRANSFER TO:
>Handset 2
p
q
Phone 0:00:12
10/15
10:01
AM
To Next Page
Loading...
