Answering system
Message playback
When messages are playing on the handset:
Press qCID/VOLUME or pDIR/VOLUME to adjust the message
playback volume.
Press EQ to adjust the message playback audio quality.
Press 6 to skip to the next message.
Press 4 to repeat the message. Press twice to hear the previous message.
Press MUTE/DELETE to delete the message.
Press 5 or OFF/CANCEL to stop the playback.
Press /SPEAKER to switch between speakerphone mode and
handset mode.
Press PHONE/FLASH to stop playback. The screen shows Call back?,
then press MENU/SELECT, PHONE/FLASH, or /SPEAKER to call back
the caller if the caller’s number is available. If the dialing format used is
not correct, then use the following option to choose the correct dialing
format before calling back the caller.
Press MENU/SELECT to pause playback and show the caller ID information
if available. From here, you can press OFF/CANCEL to resume playback,
or press # (pound key) repeatedly to show the desired dialing option
(page 72), then press PHONE/FLASH to call back the caller. If you do not
call back within ten seconds, message playback resumes automatically.
NOTE: The equalizer stays on the same settings until you change it by pressing EQ .
•
•
•
•
•
•
•
•
•
90
To Next Page
Loading...
Need help?
General
