22
Answering system
Turn answering system on or o
The answering system must be turned on to answer and record messages.
Using the cordless handset:
1. -> or -> Answering sys -> SELECT.
2. or -> Answer ON/OFF -> SELECT.
3. or to choose On or O-> SELECT.
When the answering system is on, the handset shows ANS ON.
Using the telephone base:
Ì Press /ANSWER ON to turn the answering system on or o. If the answering
system is turned on, it announces, “Calls will be answered.” If the answering
system is turned o, it announces, “Calls will not be answered.”
Message alert tone
When this feature is on, and there is at least one new message, the telephone base
beeps every 10 seconds.
Using the cordless handset or the telephone base:
1. -> or -> Answering sys -> SELECT.
2. or -> Ans sys setup -> SELECT.
3. or -> Msg alert tone -> SELECT.
4. or to choose On or O -> SELECT.
Call screening
Use this feature to choose whether incoming messages can be heard over at
telephone base when they are being recorded. If you turn call screening on, you
hear the incoming message at the telephone base. While monitoring an incoming
message, you can answer the call by pressing PHONE on the handset or
/SPEAKER on the telephone base.
Using the cordless handset or the telephone base:
1. -> or -> Answering sys -> SELECT.
2. or -> Ans sys setup -> SELECT.
3. to select Call screening.
4. or to choose On or O -> SELECT.
To Next Page
Loading...
Need help?
General
