Appendix
101
Screen display messages
Screen messages
BASE 0
is calling
The telephone base is calling.
Base
Check AC power
The base’s corded handset is lifted during an AC power failure.
If there is an AC power failure, it is still possible to dial out and
receive incoming calls using the corded handset.
Blocked call
An incoming call is blocked.
Block list
is empty
There are no call block entries.
Call
transferred
You have transferred an outside call to another device.
Caller ID log
empty
There are no entries in the caller ID log.
Calling
BASE 0
The handset is calling the telephone base (for intercom calls).
Calling
HANDSET X
The handset or telephone base is calling another handset (for
intercom calls).
The telephone base is transferring an outside call to a handset.
Call answered
The answering system has answered an incoming call.
Contact deleted
A directory entry is deleted.
Directory empty
There are no directory entries.
Directory full
The directory is full. You cannot save any new entries unless
you delete some current entries.
Ended
You have just ended a call.
HANDSET X
is calling
Another system handset is calling.
Incoming call
There is an incoming call.
Intercom
The device is on an intercom call.
Intercom ended
The intercom call has just ended.
INTERCOM TO:
You have started the intercom process, and need to enter the
number of the device you wish to call.
Line in use
An extension phone, or one of the devices is in use.
Low battery
The battery is low. You should charge the battery.
Microphone ON
Mute is off so the other party can hear your voice.
Muted
The microphone is off. The other party cannot hear you.
New voicemail
There are new voicemail messages from your telephone
service provider.
No battery
The handset in the charger has no battery installed.
To Next Page
Loading...
