Multiple handset use
45
Intercom
Use the intercom feature for conversations between two handsets, a handset
and the telephone base, or a handset/telephone base and a cordless
headset/speakerphone (sold separately). You can buy additional expansion
handsets (model AT&T CL80115), cordless headsets and speakerphones for
this telephone base to expand your telephone system (up to 12 handsets or
10 cordless handsets and two cordless headsets/speakerphones).
Using a cordless handset:
Press MENU/SELECT in idle mode to enter the main menu.
Press qCID or pDIR to scroll to Intercom, then press
MENU/SELECT.
If you have one handset and no other registered
devices, the handset shows Calling base.
If you have other registered device(s) or more than one
handset, the handset shows INTERCOM TO:. Use the
dialing keys to enter a specific device number (enter a specific device number (0 for the
telephone base, 1-9 for handsets 1-9, TONE followed
by 0-2 for handsets 10-12, # for a single headset/
speakerphone, # followed by 1 or 2 for headset/
speakerphone 1 or 2, or TONE followed by
#
for all
devices), or presspress qCID or pDIR to scroll to the desired
device and press MENU/SELECT. Your handset screen
shows Calling HANDSET X, Calling BASE 0, Calling
headset or Calling all devices.
The destination device(s) rings and shows HANDSET is calling, HANDSET
X is calling or HANDSET X is calling all (HANDSET represents the handset
name, X represents the handset number).
2. To answer the intercom call, press
PHONE/FLASH, /SPEAKERSPEAKER or
any dialing key (0-9, TONE , or
#
) on the called device. On the called
telephone base, press /SPEAKERSPEAKER or any dialing key (0-9, TONE , or
#
),
or lift the corded handset. Both devices now show Intercom.
3. To end the intercom call, one party presses
OFF/CANCEL or places the
cordless handset back in the charger, presses CANCEL on the telephone
base, or hangs up the corded handset. The other party hears four beeps.. The other party hears four beeps. The other party hears four beeps.
Both devices display Intercom ended.
1.
•
•
Using the telephone base:
1. When the telephone base is not in use, press INT. You
can also press MENU/SELECT in idle mode to enter
the main menu, then press qCID or pDIR to scroll to
Intercom and press MENU/SELECT.
If you have one handset and no other registered
devices, the telephone base shows Calling HANDSET X.
•
Calling
BASE 0
HANDSET X
is calling
Intercom
11:35
AM
12/02
Calling
HANDSET X
To Next Page
Loading...
