Appendix
139
Troubleshooting
The listening volume of my cell call is too loud or quiet.
During a cell call, if the listening volume is too loud or quiet, try changing
the volume on your cell phone. On some cell phones, changing the
volume on the cell phone effects your cell call volume on the CLP99183/
CLP99283/CLP99353/CLP99383/CLP99453/CLP99483/CLP99553/
CLP99583 handset.
The phone doesn’t play my iPhone ringtone when there is an
incoming call.
Make sure the operating system of your iPhone is iOS 4.1 or later.
Make sure you have turned on the Cell ringer feature (page 32).
The iPhone ringtone played is unclear or too loud with noise.
The quality of ringtone played on your telephone is subject to individual
ringtone characteristics.
Try using another iPhone ringtone to test the quality.
My telephone doesn’t work at all.
Make sure the power cord is securely plugged in.
Make sure you plug the battery connector securely into the cordless handset.
Make sure you plug the telephone line cord securely and firmly into the
telephone base and the telephone wall jack.
Charge the battery in the cordless handset for at least ten hours. For
optimum daily performance, return the cordless handset to the telephone
base or charger when not in use.
If the battery is depleted, it may take approximately 30 minutes to charge
the handset before it shows Low battery. See page 11 for details.
Reset the telephone base. Unplug the electrical power. Wait for
approximately 15 seconds, then plug it back in. Allow up to one minute for
the cordless handset and telephone base to reset.
You may need to purchase a new battery. Please refer to
Battery installation and charging in this user’s manual on pages 11-12.
•
•
•
•
•
•
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General
