Answering system
23
Answering system settings
Number of rings
You can set the answering system to answer an incoming call after two, three,
four, five, or six rings. You can also select toll saver, which is explained below.
By default, the answering system answers an incoming call after four rings.
To set the number of rings:
When the handset is in idle mode, press MENU/SELECT to enter the
main menu.
Press qCID or pDIR to scroll to >Answering sys, then press MENU/SELECT.
Press qCID or pDIR to scroll to >Ans sys setup, then press MENU/SELECT.
Press qCID or pDIR to scroll to >
#
of rings, then press MENU/SELECT.
Press qCID or pDIR to scroll and choose among >2, >3, >4, >5, >6
or >Toll saver.
Toll saver - the answering system answers a call after two rings if
you have new messages, and after four rings when there are no new
messages. This feature allows you to check for new messages and avoid
paying long distance charges when calling from out of your local area.
Press MENU/SELECT to save the setting.
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access code
is 19.
To change the remote access code:
1. When the handset is in idle mode, press MENU/SELECT to enter the
main menu.
2. Press qCID or pDIR to scroll to >Answering sys, then press
MENU/SELECT.
3. Press qCID or pDIR to scroll to >Ans sys setup, then press MENU/SELECT.
4. Press qCID or pDIR to scroll to >Remote code, then press MENU/SELECT.
5. Use the dialing keys to enter a two-digit number. Use MUTE/DELETE to
backspace and delete a digit.
6. Press MENU/SELECT to save the setting.
1.
2.
3.
4.
5.
•
6.
To Next Page
Loading...
Need help?
General
