Appendix
25
If you have difficulty with your phone, please try the following suggestions. For
Customer Service, visit our website at www.telephones.att.com or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
For more detailed instructions, please refer to the online Complete user’s
manual at www.telephones.att.com/manuals.
My telephone doesn’t work at all.
Make sure the power cord is securely plugged in.
Make sure you plug the battery connector securely into the cordless handset.
Make sure you plug the telephone line cord securely and firmly into the telephone
base and the telephone wall jack.
Charge the battery in the cordless handset for at least 10 hours. For optimum daily
performance, return the cordless handset to the telephone base or charger when not
in use.
If the battery is depleted, it might take approximately 30 minutes to charge the
handset before it shows Low battery. See page 4 for details.
Reset the telephone base. Unplug the electrical power. Wait for approximately 15
seconds, then plug it back in. Allow up to one minute for the cordless handset and
telephone base to reset.
You may need to purchase a new battery. Please refer to
Battery installation and charging in this user’s manual on page 4.
The display shows No line. I cannot get a dial tone.
Try all the suggestions, as mentioned above.
If the previous suggestions do not work, disconnect the telephone line cord from
your telephone and connect the telephone line cord to another telephone.
If there is no dial tone on that other telephone either, your telephone line cord
may be defective. Install a new telephone line cord.
If changing the telephone line cord does not help, the wall jack (or the wiring to
this wall jack) may be defective. Try using a different wall jack in your home to
connect your CRL81112/CRL81212 telephone, or contact your telephone service
provider (charges may apply).
I cannot dial out.
Try all the suggestions, as mentioned above.
Make sure you have a dial tone before dialing. The cordless handset might take a
second or two to find the telephone base and produce a dial tone. This is normal.
Wait an extra second before dialing.
•
•
•
•
•
•
•
•
•
•
•
•
•
Troubleshooting
To Next Page
Loading...
Need help?
General
