AT&T CRL81112 - Telephone Base and Charger Installation; Telephone Base Installation; Charger Installation

Getting started
3
Telephone base and charger installation
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this
product. To order a replacement power adapter, visit
our website at www.telephones.att.com or
call 1 (800) 222-3111. In Canada, dial
1 (866) 288-4268.
For more detailed instructions, refer to the online
Complete user’s manual at
www.telephones.att.com/manuals.
2. The power adapters are intended to be correctly
oriented in a vertical or floor mount position. The
prongs are not designed to hold the plug in place
if it is plugged into a ceiling, under-the-table or
cabinet outlet.
Plug the power
adapter into a
power outlet not
controlled by a
wall switch.
Charger installation
Install the telephone base and charger, as shown below.
Telephone base installation
Raise the antenna.•
Plug the other end
of the telephone line
cord into the telephone
jack on the back of the
telephone base.
•
Route the power
adapter cord and the
telephone line cord
through these slots.
•
Plug the small end of the telephone base power adapter into
the power adapter jack on the back of the telephone base.
•
Plug the large end of the
telephone base power
adapter into a power
outlet not controlled by
a wall switch.
•
Plug one end of the
telephone line cord
into a telephone jack
or a DSL filter.
•
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required. The
DSL filter must be plugged into
the telephone wall jack.
Telephone
line cord