AT&T DL72519 - Add a Headset

17
Bluetooth
Bluetooth setup
Add a headset
Before you begin, make sure that your Bluetooth enabled headset is not
connected to any other Bluetooth device. Refer to your headset user’s manual
to learn how to search for or add new Bluetooth devices.
To pair and connect a headset:
1. Press MENU/SELECT on the handset in idle mode.
2. Press CID or DIR to highlight Bluetooth, then press MENU/SELECT.
3. Press CID or DIR to highlight Add BT headset, then press MENU/SELECT.
The handset displays Search headset....
4. Set your headset to discoverable mode (refer to the user’s manual of your
headset). When the screen displays the found devices, press CID or DIR to
highlight your headset, if necessary, then press MENU/SELECT.
 Enter the PIN of your headset, if required. The PIN for most Bluetooth
devices is 0000 (refer to the user’s manual of your headset). Press
MENU/SELECT to continue.
When a device is successfully paired and connected, the corresponding status
icon (
2
) displays. The CELL 2 light on the telephone base turns on.
If you have trouble pairing your cell phone or headset, it may not be
compatible with your DL72119/DL72219/DL72319/DL72419/DL72519/
DL72539/DL72549. Check the Bluetooth compatibility list at
https://telephones.att.com/bluetooth.