AT&T DL72519 - Voice Guide to Set Answering; System; Call Screening

74
Answering system
Answering system settings
Voice guide to set Answering system
This feature is an alternative way for you to do the basic setup of the answering
system. You can follow the voice guide to record your own announcement, set
the number of rings, and set the message alert tone.
To use the voice guide feature:
1. Press MENU/SELECT in idle mode.
2. Press CID or DIR to highlight Answering sys, then press MENU/SELECT.
3. Press CID or DIR to highlight Voice guide, then press MENU/SELECT. You
hear a voice prompt, “This voice guide will assist you with the basic setup of
your answering system.“
4. Set up your answering system by inputting designated numbers, as
instructed in the voice guide.
Notes:
 You can press OFF/CANCEL on the handset to quit the voice guide at any time.
 Aer a power outage, the handset prompts you to set the date and time, and Smart call blocker. Aer these settings
are done or skipped, the handset then prompts if you want to set up the answering system via voice guide. Press
MENU/SELECT to start the setup.
Call screening
Use this feature to choose whether incoming messages can be heard over the
telephone base when they are being recorded. If you turn call screening on, you
hear the incoming message.
To turn on or o the call screening feature:
1. Press MENU/SELECT in idle mode.
2. Press CID or DIR to highlight Answering sys, then press MENU/SELECT .
3. Press CID or DIR to highlight Ans sys setup, then press MENU/SELECT
twice to select Call screening.
4. Press CID or DIR to choose between On and O, then press
MENU/SELECT to save.