AT&T DL72519 - Call Intercept; Temporarily Turning off the Message Alert Tone

79
Answering system
About the answering system
Options while a message is being recorded:
 Press CID/VOLUME or DIR/VOLUME on the handset to adjust the call
screening volume.
 Press /SPEAKER to switch between speakerphone mode and handset
mode.
 Press HOME/FLASH to answer the call.
Call intercept
When a caller is leaving a message on your answering system, you can stop
recording and talk to the caller by pressing HOME/FLASH or /SPEAKER on
the handset.
Temporarily turning o the message alert tone
If the message alert tone is turned on, the telephone base beeps every ten
seconds when there are new messages. Pressing any telephone base key
(except FIND HS) temporarily silences the message alert tone.
If you press X/DELETEwheninidlemodetotemporarilyturnothemessage
alert tone, there is a voice prompt directing you to press X/DELETE again
todeletealloldmessages.Themessagealerttoneistemporarilyo.Only
press X/DELETE a second time if you wish to erase all old messages in your
answering system.
The message alert tone resumes when you receive another message.