7
Getting Started
Telephone base installation (separate line jacks)
If you have separate jacks for each line, install the base as shown below. Choose a
location away from electronic equipment, such as personal computers, television sets
or microwave ovens. Avoid excessive heat, cold, dust or moisture.
Plug base power
cord transformer
into electrical outlet
Connect black line cord
to jack labeled LINE 2
Line 1 Line 2
Connect clear
line cord to jack
labeled LINE 1
NOTE:
Use only the power
cord supplied with this product.
If you need a replacement, call
1 800 222–3111.
Be sure to use an electrical outlet
not controlled by a wall switch.
Line identification
To identify phone lines, press SPEAKERPHONE,
then call one of your telephone numbers. If you
hear a busy signal, Line 1 is the number you called.
If Line 2 rings, it is the number you called.
Connect handset cord
to base handset
To Next Page
Loading...
Need help?
General
