Registration
3
HANDSET 2
Before using a new E560-1 handset, you must register it with the E5633/
E5630/E5603B/E5600 base. During registration, you must enter the 15-digit
ID number of the telephone base.The Base ID is located on the bottom of
the base unit.
The handset provided with your E5600/E5630 is
automatically registered as Handset 1. Additional
handsets will be assigned numbers in the order they
are registered (Handset 2, Handset 3, or Handset 4).
You can register a maximum of 4 handsets.
The E5633/E5603B has 3 handsets automatically
registered as Handset 1, 2 and 3. You can register
one additional handset, which will be assigned number
4.
The E5634B has 4 handsets automatically registered
as Handsets 1, 2, 3, and 4. Y
ou cannot register any
additional handsets to the E5634B.
To add a new handset:
• Make sure your handset batteries are properly
installed and charged.
• Your handset will display “SEARCHING...”.
• Press and hold the
SELECT key until the handset
displays “ENTER BASE ID”.
• Enter the 15-digit Base ID number from the
bottom of the base unit.
(E5633/E5630/E5603B/E5600)
• Press
SELECT to accept the code and complete
registration.
NOTE:
If an invalid base ID code is entered you will hear an error tone
and the handset will continue to display “ ENTER BASE ID ”. To make
corrections while entering the code, you can erase digits by pressing the
DELETE key.
Once a valid base ID code is entered and accepted by
the base unit, the new handset will be assigned the
next available handset number (Handset 2, Handset 3,
or Handset 4).You can register a maximum of four
handsets per base unit.
Handset 1
Enter base ID, then press SELECT.
ENTER BASE ID
Handset 2
Handset 3
Handset 4
To Next Page
Loading...
Need help?
General
