You can re-register handsets after de-registering from the base.
Or you can re-register handsets to a new base unit, if you have
replaced your base unit for any reason.
To re-register a handset:
• Make sure your handset batteries are properly installed and
charged.
• Your handset will display “SEARCHING...”.
• Press and hold the
SELECT key until the handset displays
“ENTER BASE ID”.
• Enter the 15 digit Base ID number from the bottom of the
base.
• Press SELECT to accept the new code and complete
re-registration.
To re-register a handset to a new base unit:
• Make sure your handset batteries are properly installed and
charged.
• Unplug the old base unit.
• Install the new base unit by plugging it into the electrical
outlet and phone jack.
• Your handset will display “SEARCHING...”.
• Press and hold the
SELECT key until the handset displays
“ENTER BASE ID”.
• Enter the new15-digit Base ID number from the bottom of
the new base unit.
• Press SELECT to accept the new code and complete
re-registration.
NOTE:
If an invalid base ID code is entered you will hear an error tone and the
handset will continue to display “ENTER BASE ID”. To make corrections while
entering the code, you can erase digits by pressing the DELETE key.
Once a valid base ID code is entered and accepted by the base
unit, the new handset will be assigned the next available handset
number (
Handset 1, Handset 2, Handset 3, or Handset 4).You can
register a maximum of four handsets per base unit.
Re-Registering a Handset
5
To Next Page
Loading...
Need help?
General
