AT&T EL52209 - Remote Access Code

Handset settings
17
Answering system settings
Remote access code
To access your answering system remotely from any touch tone phone, you
need to enter a two-digit number (10-99). Unless you change it, the remote
access code is 19.
To change the remote access code:
1. When the handset is in idle mode, press MENU/
SELECT
to enter the main menu.
2. Press MENU
/SELECT again.
3. Press TCID or DIRS to scroll to >ANS SYS SETUP, then
press
MENU/SELECT.
4. Press TCID or DIRS to scroll to >REMOTE CODE, then
press
MENU/SELECT.
5. Press TCID or DIRS to change the remote access code.
6. Press
MENU/SELECT to confirm your setting. A
confirmation tone sounds.
QMBZ!NTHT
?BOT!TZT!TFUVQ
NTH!BMFSU!UPOF
?SFNPUF!DPEF
2:
SFNPUF!DPEF
EJSFDUPSZ
?BOT/!TZTUFN