Telephone operation
20
Handset operation
Speakerphone information
During a call, press
SPEAKER
to switch between hands-free speakerphone
and normal handset use. Press
OFF/
CLEAR
to hang up.
Last number redial
To view the recently dialed numbers:
• To display the most recently called number (up to 30
digits), press REDIAL/
PAUSE.
• To view up to five recently called numbers, press
REDIAL/
PAUSE then press TCID or DIRS, or press
REDIAL/
PAUSE repeatedly.
The handset beeps twice at the beginning and at the end of the list.
Press
OFF/
CLEAR
to exit.
To redial a number:
• To dial the displayed number, press PHONE/FLASH or SPEAKER.
-OR-
• You can call the most recently called number by pressing
PHONE/FLASH or SPEAKER. Then pressing REDIAL/
PAUSE.
While reviewing the redial memory, press
MUTE
/DELETE
to delete the displayed
number.
NOTES:
1. If you use the speakerphone during LOW BATTERY
mode, the handset is not lit except for the SPEAKER
button.
2. The speakerphone uses more power than the normal
handset. If the handset battery becomes very low while
you are using the speakerphone, the call remains in
speakerphone mode until you hang up or the battery
becomes depleted. When the battery is very low, you
cannot switch a call from normal handset use to
speakerphone mode.
3. After installing the battery into the handset, the screen
may show LOW BATTERY. If you use speakerphone at
this time, the battery may become depleted. Follow the
instructions in the Battery installation & charging
section on pages 5-6.
Elapsed time
SFEJBM
999.994.3556
TQFBLFS!1;11;41
To Next Page
Loading...
