10
Getting started
Wall-mount installation
The telephone base comes ready for tabletop use. If you want to mount your
telephone on a wall, use the provided wall-mount bracket to connect with
a standard dual-stud telephone wall-mounting plate. If you do not have this
mounting plate, you can purchase one from many hardware or consumer
electronics retailers. Professional assistance may be required to install the
mounting plate.
Tabletop to wall-mount installation
To change the telephone base from the tabletop installation to wall-mount
installation, make sure you first unplug the power adapter from the electrical
outlet and the telephone line cord from the telephone wall jack.
Plug the power cord and telephone line into the telephone base. If you
are using a DSL filter, plug the other end of the telephone line into the
filter. Route the telephone line cord (or DSL filter) through the wall-mount
bracket hole.
Position the telephone base, as shown below. Insert the extended tabs of
the wall-mount bracket into the slots on the back of the telephone base
(see illustration 2). Push the telephone base down until it is securely
in place.
1.
2.
A DSL filter (not included) is
required if you have DSL
high-speed Internet service.
Wall-mount
bracket
1 2
To Next Page
Loading...
Need help?
General
