AT&T GL210 User Manual

12
Getting started
Battery installation and charging
Install the battery, as shown below. Once you have installed the battery, the
screen indicates the battery status (see the following table). If necessary, place
the handset in the telephone base or charger to charge the battery. For best
performance, keep the handset in the telephone base or charger when not in
use. The battery is fully charged aer 16 hours of continuous charging. See the
table on page 74 for battery operating times.
If the screen is blank or shows Put in charger and a ashing , you need to
charge the handset without interruption for at least 30 minutes to give the
handset enough charge to use the telephone for a short time. When the
battery is low, the handset shows Low battery and a ashing . If you are on a
call in low battery mode, the handset beeps every minute.
The following table summarizes the battery charge indicators and actions
to take.
Battery indicators Battery status Action
The screen is blank or
shows Put in charger
and ashes.
The battery has no or very
little charge. The handset
cannot be used.
Charge without interruption (at least
30 minutes).
The screen shows
Low battery and
ashes.
Battery has enough
charge to be used for a
short time.
Charge without interruption (at least
30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged, place it in the
telephone base or charger when not in use.
1. Plug the battery connector securely into the socket inside the handset
battery compartment. Insert the supplied battery with the label
THIS SIDE UP facing up, as indicated.
THI
S SIDE
U
P
/
CE
CÔTÉ VERS LE HAUT
Batt
ery Pack / Bloc-piles :
BT
183342/BT
2
83342 (2.4V 400mAh Ni-
MH)
WA
RNING /
A
VERT
ISSEMENT :
DO
NOT BURN OR PUNCTUR
E BA
TTERIES.
NE PAS INCINÉRER OU PERC
E
R LES PILES.
Made i
n China / F
abriqué en chine CR1
535
THIS SIDE UP

AT&T GL210 Specifications

General

Brand	AT&T
Model	GL210
Category	IP Phone
Language	English