Equipment Feature Using
Intercom
Equipment Feature
To Dial
Manually
To Use On
a Button
Message Light On
Turns on the message light on an MLS- or
MLC- model phone.
Message Light Off
Turns off the message light on an MLS-
or MLC-model phone.
Call Forwarding
Forwards calls from your extension to a
destination extension. Programming this
feature on a button with lights will let you see
at a glance if your calls have been
forwarded. Unless Do Not Disturb is on,
phone will beep once each time a call is
forwarded. (To cancel Call Forwarding, enter
your own extension jack number as the
destination.)
Direct Line Pickup
Lets you access a ringing, held, or active
call on a line not assigned to your phone.
Call Pickup
Lets you answer a call ringing at a
specific extension.
Dial [
Feature ] [ 0 ] [ 9 ]
+ Ext. Jack Number
Dial [ Feature ] [ 1 ] [ 0 ]
+ Ext. Jack Number
Dial [ Feature ] [ 1 ] [ 1 ]
+ Your Ext. Jack Number
+ Destination Ext. Jack
Number
Dial [ Intercom ] [ 6 ] [ 8 ]
+ two-digit line jack
number (01-24)
Dial [ Intercom ] [ 6 ]
+ Ext. Jack Number
Press the button +
Ext. Jack Number
Press the button +
Ext. Jack Number
Press the button +
Your Ext. Jack
Number +
Destination Ext.
Jack Number
Press the button, then
dial the two-digit line
jack number (01-24)
Press the button
* The features shown on this page require extension jack numbers or line jack numbers. See your
System Manager for a list of those numbers.
6
To Next Page
Loading...
