AT&T Plant Series - 2.04 Optional Components; 2.05 Associated Apparatus; 2.06 Replaceable Common Components; 2.07 Customer Instruction Booklet

SECTION 502-304-101
2.04
Optional Components ( order separately ):
e Cord, Handset, H5AA-* 5 feet-6 inches, 9
and 13 feet (Required when providing tip
identifying ground)
e Cord, Handset , H5AD-* 5 feet-6 inches only
(Equipped with Message Waiting Lamp}
e P-90D231 Polarity Guard Assembly
2.05 Associated A ppara tus or Equipment:
e 2012A Transformer (for other suitable
trans formers, see section on transformers)
2.06 Replaceable Common Components:
e Lamp, 53B (replacement for all hand telephone
sets)
e Lamp, 5 1B (current production hand telephone
sets)
e P-82E8-* Cover
e P-25E803 Number Card Retainer
e P-28E320 Light Seal
e Form, E-5002A
(number card)
e Ringer,
PlA
e Card ,F ace,Dial (see Table A)
* Refer to Table A for color suffix.
2.07 A customer instruction booklet (GN-2433) is
sh ipped lose with the hand telephone set
and should be left with the customer.
Design Features
2.08 The 1220A hand telephone set provides the
following features:
elllu minates 10-button TOUCH-TONE@ dial.
Note: Early production handsets will have
the lamp in a vertical position, current
production handsets have the lamp in horizontal
position.
Page 2
TABLE A
COLOR SELECTION AND PIECE PART INFORMATION
HAND TELEPHONE DIAL FACE CARD
STANDARD
SUFFIX COLOR
PIECE
COLOR*
PART
NO .
Black -03
Slate P-22F570
Ivory
-50
Cinnamon P-22F571
Brown
Green
-51 Dark
P-22F572
Jade Gray
Red -53
Burgundy
P-22F573
Yellow
-56
Gold
P-22F574
White
-58
Slate
P-22F570
Rose Pink
-59
Rose
P-22F575
Lt. Beige
-60 Sandalwood
P-22F576
Lt. Gray
-61 Slate
P-22F570
Aqua Blue
-62
Pea coc k Blue
P-22F577
Turquoise
-
64
Turquoise Green P-22F578
*Refer to Section 500-120-100 for promoted colors.
e Equipped with recall switch.
e P-82E800 type cover or number card and
associated retainer can be used to conceal
housing
screws and lamp.
Note: 1220-type hand telephone sets may
be found in the field with a number card or
cover used to conceal the screws in the
handset. Current production sets will have
the number card in the base since this is a
more convenient location for the customer.
e Equipped with jack (Fig.
3) to accommodate
a plug ended
handset cord (Fig. 4).
2.09 ACl and ADl telephone base provides the
following features:
e Factory-wired for individual or bridged
service.
e Adjustable
ringer volume control.
0
0
0
0
0
TCI Library: www.telephonecollectors.info